Certificate Number: 255416-2516776 Project Number: 2516776 Page Number:74
INSTALLATION AND OPERATION MANUAL
MARANA FORNI srl unipersonale
via Turbina 98 37139 Chievo-Verona-Italia
tel. +39 045 6704503 - fax +39 045 7156118
www.maranaforni.it - [email protected]
Skype: maranaforni
VER
2.1
© Riproduzione vietata
PAG
18 / 27
1. TO SWITCH ON / OFF
With the green light indicating that the electricity supply is connected (lightning), press the
ON/OFF button
for a moment; the display will light up indicating, after about ten seconds, the
temperature reading inside the oven (red light above the thermometer will be on); the rotation
speed of the plate
will be that of “oven standby”.
To switch off the console, press the
ON/OFF
button for a few seconds until it switches off.
Use the
“EMERGENCY”
button only in case of necessity.
2. BASE LEVEL COOKING
Move the joystick down for a moment (towards the lit
dot above the “clock” symbol); the
rotation speed of the plate will change to the optimal speed for cooking; the display will show
the cooking time remaining, with time being counted down; ten seconds before cooking is
finished, there will be a short warni
ng sound indicating “cooking almost finished” and at the end
there will be three short sounds.
3. TO IMMEDIATELY HALT COOKING IN PROGRESS
For all cooking methods or pre-heating the plate, keep the joystick pressed downwards for a
couple of seconds. Cooking or pre-heating will stop immediately, and the plate will descend to
the base (function RESET).
4. TO STOP ROTATION OF THE PLATE
Press the ON/OFF button for a moment; the plate will slow down and then stop. Pressing the
button again in the same way will cause the rotation to return to the normal speed again.
5. TO VARY THE COOKING TIME
During the “standby” phase, press the “SET” button for a moment; the gr
een light near the clock
symbol will flash; duration of the cooking time will be shown on the display. The time can be
increased or decreased as desired by pushing the joystick (to the right or left); keep the SET
button pressed to confirm or wait for the
automatic “exit”.
6. TO VARY THE ROTATION SPEED OF THE PLATE DURING COOKING
Briefly press the SET button twice (the green led with the entering hare will flash). With the
joystick t or
–
increase or decrease the revolutions per minute as desired. Exit from the
regulation mode by keeping the “SET” button pressed for a few seconds or wait for th
e
automatic exit.
7. TO VARY THE ROTATION SPEED OF THE PLATE DURING
“EXTRACTION”
At the end of the cooking time, the extraction time begins. The rotation speed can be set by
pressing the “SET” button three times (the green led with the exiting hare will
flash); use the
joystick to increase or decrease the revolutions/minute as desired.
Exit from the regulation mode by keeping the “SET” button pressed for a
few seconds or wait
for the automatic exit.
