Certificate Number: 255416-2516776 Project Number: 2516776 Page Number:74
INSTALLATION AND OPERATION MANUAL
MARANA FORNI srl unipersonale
via Turbina 98 37139 Chievo-Verona-Italia
tel. +39 045 6704503 - fax +39 045 7156118
www.maranaforni.it - [email protected]
Skype: maranaforni
VER
2.1
© Riproduzione vietata
PAG
15 / 27
8. TO VARY THE COOKING TIME
During the “standby” phase, press the “SET” button for a moment; the green light near the clock
symbol will flash; duration of the cooking time will be shown on the display. The time can be
increased or decreased as desired by pushing the joystick (to the right or left); keep the SET
button pressed to confirm or wait for the automatic “exit”.
9. TO VARY THE ROTATION SPEED OF THE PLATE DURING COOKING
Briefly press the SET button twice (the green led with the entering hare will flash). With the joystick
towards + or
–
increase or decrease the revolutions per minute as desired. Exit from the
regulation mode by keeping the “SET” button pressed for a few seconds or wait for the
automatic exit.
10. TO VARY THE ROTATION SPEED OF THE PLATE DURING
“EXTRACTION”
At the end of the cooking time, the extraction time begins. The rotation speed can be set by
pressing the “SET” button three times (the green led with the exiting hare will flash); use the
joystick to increase or decrease the revolutions/minute as desired.
Exit from the regulation mode by keeping the “SET” button pressed for a few seconds or wait
for the automatic exit.
11. TO CHANGE ROTATION DIRECTION OF THE PLATE
Switch off the control panel with the ON/OFF button, keeping the joystick lever pushed
towards the desired rotation direction (left or right). Switch on the control panel again with the
same button, releasing the lever after hearing a short sound.
12. TO CHANGE THE SOUND OF THE ACOUSTIC SIGNALS
Keeping t
he “SET” button pressed
even after obtaining the desired sound, move the joystick
lever (towards the left or right) to modify the sound as desired; when the joystick is released,
the sound will be permanently memorised.
13. TO POSITION THE PLATE FOR MAINTENANCE
Switch off the control panel with the ON/OFF button, wait a few seconds, then switch on
again, keeping the joystick lever pushed upwards until all the horizontal lines appear on the
display.
At this point, rotation is blocked and with the joystick (pushed upwards), the plate can be
raised or lowered as desired, even if the temperature is below 150°C.
14. CONTROL VERSION OF PROGRAMME
For the first 5 seconds after switching on (with the ON/OFF button), the display shows which
release of the function programme version is being
used: “
r.07
” = release 7.
