AVS S-SERIES INSTALLATION MANUAL - GEN 2 VER 5
21
Programming functions Register 2
Vehicle set up: Open a door, close bonnet & boot, arm & disarm alarm then turn ignition on, off & on.
Feature:
Second vehicle control -
button used to arm/disarm this vehicle (vehicle B)
Press the
button
this many times:
2
Factory setting:
OFF
Description:
When turned ON this feature allows the remote to be divided to act like two separate
single button remotes to control two separate vehicles i.e. the
button controls
vehicle A, the
button controls vehicle B.
1.
Simply teach all remotes into both vehicles. Refer to Learning new remotes. The
button will no longer work on vehicle B.
2.
After programming all remotes into both vehicles turn this function ON in vehicle B
ONLY. Vehicle A needs no further programming.
Feature:
Digital shock/glass break sensors (S4 and or S5 only)
Press the
button
this many times:
3
Factory setting:
ON
Description:
Turn this feature OFF to disable the digital shock and glass break sensors.
Feature:
Automatic re-arm and re-lock
Press the
button
this many times:
4
Factory setting:
OFF
Description:
This feature prevents the accidental system disarming of the system. When turned ON it
will re-arm and re-lock the doors if the system is disarmed and a door not opened within
60 seconds. If turned on dome light extension will be turned off automatically. Installers
must wire up the door circuit for this feature to function.
Feature:
Timed negative on arm
Timed headlight delay for 15 seconds
Press the
button
this many times:
5
Factory setting:
OFF
Description:
When turned ON, this feature changes the –ARM wire from being a constant negative
on arm to a timed 15 second negative on arm wire. This allows you to connect this wire
via a relay (see Timed Headlight diagram) to the headlight circuit, so that when the
system is armed, the headlights will turn on for 15 seconds, and then automatically
switch off.
The user can press the
button on the remote to turn the lights turn off before the
end of the 15-second period if this feature is turned on.
Note: a window roll-up module can still be connected to this wire as long it takes less
than 15 seconds for the windows to roll up. If you have turned the ‘Negative on
alarm/pager out’ feature on in Register 1, Feature 7, when you turn this feature on,
‘Negative on alarm’ will automatically reset back to off.
