AVS S-SERIES INSTALLATION MANUAL - GEN 2 VER 5
16
Programming features Register 1 continued
Vehicle set up: Close all doors, bonnet & boot, arm & disarm alarm then turn ignition on, off & on.
Feature:
Instant boot release/On board turbo timer shut down
Press the
button
this many times:
6
Factory setting:
OFF
Description:
When this feature is ON, the boot release button will only require pressing once rather
than holding down for three seconds to open an electric boot or shut down the On-
board turbo timer before the preset time.
Feature:
Negative on alarm/pager out
Press the
button
this many times:
7
Factory setting:
OFF
Description:
When this feature is ON, the –ARM wire changes to become ‘negative on alarm’ instead.
Can be used to power pagers or internal sirens.
Feature:
Dome light extension
Note: this feature cannot be turned on if auto re-arm and re-lock is turned on (refer
REGISTER 2 feature 4)
Press the
button
this many times:
8
Factory setting:
OFF
Description:
When this feature is ON the dome (interior) light comes on automatically when the
system is disarmed via remote, enabling the owner to verify the vehicle is safe inside. The
light stays on for 20 seconds, or until the ignition is turned on. The dome (interior) light
also comes on automatically when the ignition is turned off, enabling the owner to
quickly gather belongings before exiting the car. The light stays on for 20 seconds, or
until the system is armed via remote, or until the ignition is turned on again. This
function only works if the door wire is connected directly to the interior light door
sense wire.
Feature:
Inhibit / Enable mode selection for factory remote interface inputs
Refer to Factory Remote interface (MAP function) for full details
Press the
button
this many times:
10
Factory setting:
INHIBIT (1 chirp in inhibit mode, 2 chirps in enable mode)
Description:
Inhibit mode: NEG1 and NEG2 become ‘inhibit’ wires which stop the factory remote
interface from arming/disarming the alarm i.e. usually connected to the key barrel or
dash switch wires so that when the door is unlocked manually or by pressing the dash
switch it will NOT disarm the alarm.
Enable mode: POS2 input becomes an ‘enable’ wire which must receive a positive pulse
to ‘enable’ the upgrade interface to arm/disarm the system when they receive a trigger
from the door motor. This is usually connected to the indicators as they will activate only
when the factory remote is pressed.
