ECODRIVE DKC01.1/DKC11.1 Drive Controllers
Preparing for Startup
12-1
DOK-ECODRV-DKC01/11.1*-PRJ3-EN-P
12
Preparing for Startup
Required equipment
The following equipment is necessary when starting operation of an
ECODRIVE drive system:
•
measuring devices
•
a personal computer (PC)
•
connecting cables (PC-DKC)
•
setpoint generator
The following measuring devices are required so that torque, current and
speed can be measured as analog signals at the analog outputs:
•
a multimeter for measuring voltage (suffices for series startups) and
•
an oscilloscope or recorder (only needed for recording the signal se-
quences during startup operation for prototypes).
The PC is needed for programming, parameterization and diagnostics
during startup operation and service procedures.
Hardware requirements:
•
IBM compatibility
•
80386-SX microprocessor (80486 recommended)
•
at least 4 MB RAM memory (8 MB recommended)
•
harddisk with at least 2.5 MB of free storage space
•
3.5" floppy disk drive with a capacity of 1.44 MB
•
one free serial RS-232 interface in the PC (COM 1 or COM 2)
•
an EGA monitor or monitor with higher resolution
•
a mouse or compatible pointing device
Software requirements:
•
The operating system DOS 5.0 or higher
•
Windows 3.1 or higher
•
DriveTop startup program (floppy disk is included with ECODRIVE)
To connect a PC with a 9-pin D-subminiature connector, use cable type
IKS101.
To connect a PC with a 25-pin D-subminiature connector, use cable type
IKS102.
Pin assignment of the cable Fig. 4-19.
Measuring devices
Personal computer (PC)
Connecting cables (PC-DKC)
Buy: www.ValinOnline.com | Phone: 844-385-3099 | Email: [email protected]
