Manitou B-E2 Series Operator'S Manual Download

Page: 72 / 134

2 - 42

12 - CUTTING OFF "SIMPLE" HYDRAULIC MOVEMENTS

The function which cuts hydraulic movements is used to automatically stop dangerous movement of the jib when you are close to
the limit of longitudinal stability. However, lateral stability can reduce the load char t in its upper par t and this reduction is not
detected by the longitudinal stability alarm.

The operator must respect the lift truck's load chart.

All attachments with a suspended load (winch, crane jib, crane jib with winch, hook, etc.) MUST be used with a lift truck equipped with
a working hydraulic movement cut-out device.

1st FITTING

OPERATION

Switch A allows you to cut off "SIMPLE" hydraulic movements or not.

WITH CUT-OUT OF "SIMPLE" HYDRAULIC MOVEMENTS: SWITCH A IN POSITION A2
(VISUAL INDICATOR OFF):

Led B4 indicates that the lift truck has reached the authorized limit of longitudinal
stability and all hydraulic movements are neutralised.

The sound alarm goes off at the same time.

- To restar t hydraulic movement, proceed as follows:
- Hold switch A in position A1.
- Only per form de-aggravating hydraulic movements in the following order: jib retracted and

raised.

- Reset switch A to position A2.

NOTE: When the jib is retracted, the function for switching off "SIMPLE" hydraulic movements is disconnected.

WITHOUT CUTTING-OUT "SIMPLE" HYDRAULIC MOVEMENTS: SWITCH A IN POSITION A1 (VISUAL INDICATOR ON):

To allow the use of loading or ear th moving buckets, for example.

In this case, the user is only informed by the longitudinal stability alarm system B (see: 2 - DESCRIPTION: 5 - LONGITUDINAL
STABILITY ALARM SYSTEM).

Hydraulic movements are not cut off.

The sound alarm is disconnected.

See operator's manual for use and description.

NEUTRALIZATION OF HYDRAULIC MOVEMENTS: SWITCH A IN POSITION A3 (VISUAL INDICATOR PARTIALLY ON):
When driving on the road, it is highly recommended (mandator y in Germany) that you cut-off all the hydraulic movements.

2nd FITTING

OPERATION

Switch A allows you to cut off "SIMPLE" hydraulic movements or not. The cutting-off of
"SIMPLE" hydraulic movements is automatically enabled when the lift truck is star ted-up.

WITH CUT-PUT OF "SIMPLE" HYDRAULIC MOVEMENTS: VISUAL INDICATOR A1 OFF:
- Led B4 indicates that the lift truck has reached the authorized limit of longitudinal

stability and all hydraulic movements are neutralized.

- The sound alarm goes off at the same time.
- To restar t hydraulic movement, proceed as follows:
- Press the bottom of switch A, visual indicator A1 comes on and indicates that the

hydraulic movement cut-out is disabled.

- Only per form de-aggravating hydraulic movements in the following order: jib retracted and

raised.

- Re-enable the hydraulic movement cut-out by pressing the top of switch A, visual indicator

A1 will go out.

NOTE: When the jib is retracted, the function for switching off "SIMPLE" hydraulic movements is disconnected.

WITHOUT CUTTING-OUT "SIMPLE" HYDRAULIC MOVEMENTS: TAB C HELD DOWNWARDS AND SWITCH 'A' IN POSITION A1 (VISUAL
INDICATOR ON):
- To allow the use of loading or ear th moving buckets, for example.
- In this case, the user is only informed by the longitudinal stability alarm system B (see: 2 - DESCRIPTION: SPECIAL

ADAPTATIONS: 2 - LONGITUDINAL STABILITY ALARM SYSTEM).

NEUTRALIZATION OF HYDRAULIC MOVEMENTS: SWITCH 'A' IN POSITION 'A3' (VISUAL INDICATOR OFF):
- When driving on the road, it is highly recommended (mandator y in Germany) that you cut-off all the hydraulic movements.