M&R 12 COLOR, Manual

Page: 59 / 241

E 300 Operator Interface
M&R Printing Equipment, Inc. - Glen Ellyn, Illinois
51
Duration”, Rear Delay”, “Rear Duration”,
“Revolution #:” and “Pallet #:”.
To access the first menu item, “Spray 1 Revltn
Only” press the “ARROW DOWN” key one time.
Now press the “ARROW RIGHT” key one time.
The flashing cursor will now be positioned at the
“ON/OFF” indication. To activate “Spray 1 Revltn
Only” press the “ENTER” key one time. The indica-
tion will now display “ON”. When “Spray 1 Revltn
Only” is “ON”, the M&R Annamister will dispense
adhesive on all pallets for one revolution only. A rev-
olution is defined as one complete cycle of all print-
ing pallets. This control provides a convenient man-
ner in which to automatically apply adhesive to all
printing pallets at the beginning of a print run.
Press the “ARROW DOWN” key one time, then
press the “ARROW RIGHT” key one time to access
the “Spray Every Revolution” sub-menu item. The
“Spray Every Revolution” menu item permits the
system Operator to program the M&R Annamister to
apply adhesive to the printing pallets based on the
number of revolutions of the press. Remember that a
revolution is defined as one complete cycle of all
printing pallets. The value may be set for a minimum
of “0”, or a maximum of “99”. As an example, if the
indication is set for “5”, then the M&R Annamister
system will automatically apply adhesive to all print-
ing pallets every fifth revolution of the index system.
To change the indication, use the numerical keys to
enter the desired number of revolutions, then press
the “ENTER” key one time. Your selection is now
saved in the PLC memory.
Press the “ARROW DOWN” key one time, then
press the “ARROW RIGHT” key one time to access
the next sub-menu item, “Front Delay”. This sub-
menu item permits the system Operator to program
a start delay time for the front air valve which oper-
ates the two front spray guns.
This adjustment is provided to precisely set the
spray gun trigger cycle to the speed of the indexer
when operating the press in the automatic mode.
Figure 11
Servo Offset:
End Position : 0.000”
Strt Position: 0.000”
TIMERS nozzle TESTS MPR Pg Dwn Pg Up