M&R 12 COLOR, Manual

Page: 58 / 241

E 300 Operator Interface
M&R Printing Equipment, Inc. - Glen Ellyn, Illinois
50
head is currently selected for print operation, or the
letter “F” indicating that the print head is selected for
flash cure operation. To change the indication from
flash to print operation and back again, use the
“FRONT/REAR” stop toggle switches located on
the Main control console to select the desired oper-
ation of that particular print head. To select the print
head for flash cure operation, place the toggle
switch in the “FRONT” stop position, then, using the
“ARROW” keys, place the flashing cursor under the
letter “E” in the word “ENTER” to the right of the
word “FLASH”, and press the “ENTER” key. In addi-
tion, the “SINGLE/DOUBLE” toggle switch must
also be selected, or the print head will not operate in
either print or flash operation. (See illustration below)
Servo Offset:
Scrolling down further in this menu will reveal the
word “Servo Offset” and below this “End Position”
and “Start position”. These controls are used to
program the stopping position of the indexer servo
drive system for the most optimum locking of the
carousel. This control is provided to adjust index
stop after changing pallets to a smaller or larger size.
Larger pallets increase the mechanical load as seen
by the indexer, while smaller lighter pallets decrease
the index load. As a result, changing of printing pal-
lets can have an impact on the stopping position,
and ultimately, the smooth operation of the index
servo drive system.
The range of setting is from -0.25” to + 0.25”. To
change the setting for either “Strt” or “End”, use the
arrow keys to place the flashing cursor on either the
“-“ sign, or the “+” sign. Now press the “ENTER”
key and hold it down until the desired numerical
value, either plus or minus is displayed. Then release
the “ENTER” key. Your selection is now pro-
grammed into the Servo Drive Offset. (See Figure 11
next page)
Glue Applicator:
The “GLUE APPLICATOR” sub-menu provides con-
trol adjustments for the optional M&R Annamister
Automatic Adhesive Application system. The avail-
able parameters are “Spray 1 Revltn Only:” ,”Spray
Every: Revolution” “Front Delay”, “Front
Figure 10
Flash: WAIT
181716151413121110 9 8 7 6 5 4 3 2 1
F
Servo Offset:
End Position: 0.000”
TIMERS nozzle TESTS MPR Pg Dwn Pg Up