Malaguti 500 cc 4T, Service Manual, Page: 33 / 78

32 10/07
- Install a new gasket on the engine
crankcase.
- Check the presence of the three
centring dowels.
- Turn the crankshaft in order to align
the countershaft movement sensor with
a reference point on the crankcase (see
figure).
- Repeat the alignment for the water
pump crankshaft using the same
reference point on the engine.
N.B.
THIS PREPARATION IS USEFUL
PARTICULARLY IN THE EVENT OF
REPAIRS WITH THE WATER PUMP
COVER INSTALLED.
- Install the flywheel cover on the engine,
paying attention to avoid interference
between the stator and rotor.
FAILURE TO OBSERVE THIS
INSTRUCTION MAY RESULT IN
DESTRUCTION OF THE CERAMIC
MAGNETS.
THE INTERMEDIATE BOLTS FOR THE
REMAINING MOUNTING POINTS WITH
THE EXCEPTION OF THE BOLT FOR THE
MANIFOLD SUPPORT (SHOWN IN THE
FIGURE) ARE SLIGHTLY LONGER.
- Tho lock the 14 retaining bolts of the
cover to the prescribed torque.
N.B.
THE BOLTS HAVE FOUR LENGTHS:
- THE 3 SHORTEST ARE INSERTED AS
SHOWN IN THE FIGURE.
- THE LONGEST IS INSERTED UNDER THE
ENGINE OIL FILLER PLUG.
Locking torques (N*m)
Flywheel cover screws
11 - 13