25
3. GAS EXHAUST SYSTEM
3.1 INTRODUCTION
Gas-heated convection ovens are classified according to
“
Construction type
” on the basis of the combustion
technology used. Each type of appliance must therefore be
fitted with the specific gas exhaust system stipulated by
applicable standards.
Before installing the exhaust system, you must therefore:
a) Identify the “
Construction type
” of your oven model by
referring to
Table 1
(Technical Data) or the appliance
identification plate;
b) Select the construction type diagram from those
illustrated below featuring the type of gas exhaust system
needed to evacuate the exhaust gas from the installation
site (e.g. :exhaust pipe under extractor hood, externally-
ducted or centralised flue exhaust system).
3.2 INSTALLATION OF ACCESSORIES
The accessories may be easily mounted using the figures
and corresponding key illustrated below as a reference.
The fixing screw holes for accessory “
A
” are 3.5 mm in
diameter. These holes must be drilled on site where
marked on top of the oven.
Summary of Contents for MKF-20G
Page 5: ...5 MKF 40G 3 1 4 5 6...
Page 20: ...20 MKF 40G 3 1 4 5 6...
Page 33: ...33 MKF 20G MKF 40G KUMANDA PANEL CONTROL PANEL...
