P 17/ 24
R
epair
[4] DISASSEMBLY/ ASSEMBLY
[4]-5. Valve, Crank, Driver complete, Cushion
DISASSEMBLING
ASSEMBLING
(1) Remove Motor housing set from Gear assembly. Refer to
pages 10 and 11
.
(2) Remove Driver complete as drawn in
Fig. 19
.
Fig. 19
1. Remove M4x6 Hex socket head bolt,
and then separate Arm from Center plate.
5. Remove Retaining ring (EXT) S-19 with 1R291,
and then separate Link arm B.
6. Remove four M4x30 Hex socket head bolts,
and then separate Cylinder head and Separator
from Driver cylinder.
2. Following the steps mentioned in
page 14
, remove
Switch base section.
3. Following the steps mentioned in
page 15
, remove an module
of Sub arm and Link arm A, etc.
4. Following the steps mentioned in
page 15
, remove Top cap.
And then remove Rear cushion and Compression spring 11.
M4x6 Hex socket head bolt [2.7-4.2 N·m]
Arm
Center plate
Link arm B
Cylinder head
Valve
Gasket A
Driver cylinder
Gasket B
O ring 24
Separator
O ring 21
M4x30 Hex socket head
bolt [2.0-3.0 N·m]
1R291
(Refer to Fig. 15
for the shape of
1R291.)
Retaining ring
(EXT) S-19
7. Remove three M4x16 Hex socket head bolts, and then separate Driver cylinder section from Cylinder end.
Cushion and Driver complete can be removed at this time.
Assemble the components by reversing the disassembly procedure.
Note
: • Following to the steps mentioned in
pages 19 and 20
, assemble and adjust Sub arm and Link arm A.
• Move the crank portion to the lower dead point, and install the module of Motor housing and Main cylinder into
Housing L. (
Fig. 16 of Page 13
)
M4x16 Hex socket
head bolt (3 pcs.)
[2.7-4.2 N·m]
M4x16 Hex socket
head bolt (3 pcs.)
*Cushion “P”
*The components of Driver assembly
Driver assembly
Driver cylinder
Cylinder end
*O ring 24
Cushion
