S12800 Routing Switch Installa
tion Manual V1.0
Maipu Confidential & Proprietary Information
Page 47
Connection steps:
Step 1:
Insert one side of the Ethernet twisted pair to the Ethernet electrical interface of
the switch (RJ-45 port).
Step 2:
Insert the other side of the Ethernet twisted pair to the RJ-45 port of the device
connected to the network.
4.2.2 Access Network via LC Fiber
For the SFP, SFP+ and LC QSFP+ optical interface of the switch, you can use the LC fiber to
connect the network. Before connecting fiber, first install the optical module to the switch and
then insert the fiber connector to the optical module. The appearance of the general LC fiber
connector is as shown in the following figure:
Figure 4-13 Appearance of the LC fiber connector
I n s t a l l O p t i c a l M o d u l e
The installation steps of the SFP/SFP+ and LC QSFP+ modules are similar. The following takes
the SFP module as an example. The steps are as follows:
When installing the SFP module, do not use the hands to touch the gold-finger of the SFP
module directly.
The TX wire should be connected to the RX wire of the peer router; the RX wire should be
connected to the TX wire of the peer router.
Step 1:
Wear the anti-static wrist and confirm that the anti-static wrist is well
contacted with the skin and well-grounded.
Step 2:
Pull out the dust plug on the optical port of the switch, as shown in Figure 4-
14.
Step 3:
Get the SFP module out from the packing box. The diagram of the SFP module
is as shown in Figure 4-15 Use the hands to hold the two sides of the SFP
module and push it into the interface slot of the switch horizontally until the
SFP module is close-contact with the slot (you can feel that the shrapnel at the
top and bottom of the SFP module stuck the interface slot), as shown in Figure
4-16.
