S12800 Routing Switch Installa
tion Manual V1.0
Maipu Confidential & Proprietary Information
Page 132
F.2
Recommended Line Bundling
The bundling of the power cables
Appendix figure F-2 Cable bundling
After being bundled in the cabinet, the cables should be straight and neat, and there is no
twisting or bending. The diagram of the cable bundling is shown in the following figure:
Appendix figure F-3 Cable bundling
The cable bending radius should be no less than 2 times of the cable diameter. At the
outlet of the connector, the bending radius should be no less than 5 times of the cable
diameter.
Different types of cables (power cable, signal cable, ground cable and so on) should be
arranged and bundled separately in the cabinet and cannot be bundled together. When
they are close to each other, you can adopt the cross-wiring. When parallel-wiring, the
distance between the power cable and the signal cable should be no less than 30mm.
The bundling rack and cabling slot inside and outside of the cabinet should be smooth and
without sharp edges.
After using the cable ties to bundle the cables, cut the extra parts. The cut should be
neatly and without sharp corners, as shown in the following figure. The diagram of the
cable bundling is as follows:
Appendix figure F-4 The cable bundling
