MP1800-10 3G Router User Manual
Maipu Confidential & Proprietary Information
Page 39 of 95
Dynamic route configuration interface
Enable
: Whether to enable the RIP service;
Version
: Select the RIP version, that is, RIPv1 and RIPv2.
Receive V1’s packet
: When selecting RIPv2, select whether to receive
RIPv1 packets.
Enable Source Check
: Select whether to detect the source address of
the point-to-point interface. By default, it is disabled.
Update Interval
: Update time of RIP route, the interval of sending the
route information.
Failure time
: Set the invalid interval of the route information. If not
receiving update packets after exceeding the time, set the route
information unavailable, but do not clear the route information.
Lock time
: Set the locking time of the route information. The lock time is
to prevent the route loop.
Refresh time
: The time of clearing the route information. When the route
entry enters the invalid state, enable the refresh timer. If not receiving the
update packets after exceeding the time, clear the related route
information.
Publish Route
: Tick the desired interface. If not ticking, the interface
does not send or receive the route update information.
2.
Neighbor
Enter
Network
>
Dynamic route
, as follows:
