16 Series, Model - 2816 4WD
T
O
ADJUST
THE T
OE-IN, USE THE FOLLOWING PROCEDURE:
1
.
Loosen the lock nuts at both
turnbuckle ends to allow the tie
rod turnbuckle to turn freely
.
2
.
T
urn the turnbuckle to shorten or
lengthen the tie rod length.
3
.
Make sure the correct toe-in is
obtained. If not, adjust the tie rod
length again.
4. After adjusting the toe-in, tighten
both lock nuts to a torque of 59
to 88 Nm (43 to 65 lb ft).
NOTE:
1.
The RH side T
ie-Rod has a LH thread and the LH side
T
ie-Rod has a RH thread.
When loosening or tightening the lock-nut, or adjusting the
T
ie-Rod, make sure that ...
(1
)
RH side T
ie-Rod
Unlock
:T
urn the lock-nut clockwise
Lock
:T
urn the lock-nut counterclockwise
Lengthen
:T
urn the T
ie-Rod counterclockwise
Shorten
:T
urn the T
ie-Rod clockwise
(2
)
LH side T
ie-Rod
Unlock
:T
urn the lock-nut counterclockwise
Lock
:T
urn the lock-nut clockwise
Lengthen
:T
urn the
T
ie-Rod clockwise
Shorten
:T
urn the T
ie-Rod counterclockwise
2.
One turn of the T
ie-Rod makes about 12 mm (a half inch)
dif
ference of the T
oe-in.
LOCK NUT
TIE-ROD
TURNBUCKLE
83
TIRES/WHEELS/SP
ACING/BALLAST
_______________________________________
