16 Series, Model - 2816 4WD
POWER
TAKEOFF
(PT
O)
P
T
O driven machinery can cause serious injury or death, usually due
to wrapped clothing. When required by the job to be in the drive shaft
area, stay clear of rotating parts. Before working on the drive shaft,
or servicing or clearing the driven machine, where applicable on this
tractor
, put the PT
O clutch lever in the DISENGAGE position, the PT
O
lever in the NEUTRAL
or OFF
, and ST
O
P
the engine
M125A
Rear
PTO
The rear PT
O is a 540 RPM with
a 34.9 mm(1 3/8 inch) diameter 6
spline output shaft.
ENGAG
E THE REAR PT
O AS
FOLLOWS:
1.
Push the clutch pedal fully
.
2
.
Move the PT
O control lever
fo
rward or rearward.
3.
Release the clutch pedal slow-
ly
.
DISENGAGE THE REAR PT
O
AS FOLLOWS:
1.
Push the clutch pedal fully
.
2.
M
ove the PT
O control lever to
the
OFF (Engine Start) slot.
NOTE:
Keep the PT
O control
lever in the OFF (Engine Start)
slot when starting the engine and
whe
n the PT
O is not being used.
3.
Release the clutch pedal slow-
ly
.
The following table shows the required engine speed to get the required
Rea
r PT
O output shaft speed.
P
T
O Output
Shaft Speed
540 RPM
Required
Engine Speed
2376 RPM
REAR P
TO
SHAFT
CLUTCH PEDAL
REAR PT
O
CONTROL LEVER
54
OPERA
TING INSTRUCTIONS
____________________________________________
