Maguire Products FLEXBUS, Instruction Manual

Page: 13 / 29

M A G U I R E P R O D U C T S , I N C .
13
M A G U I R E

FLEXBUS™
Load Retry - The number of times the receiver will try to successfully load
material and satisfy the sensor. Exceeding this retry count will cause the receiver
to alarm.
Dump Time - The time in seconds that the receiver will remain open during the
dump cycle.
Pump Assignment - The ID number of the pump that this receiver is assigned to.
Layers - Number of layers Regrind will be dispensed in with natural. Zero turns on
automatic layering. Maximum 4 layers.
Percent of Regrind - When a non-zero % value is specified, this will dispense
regrind as a % of load time. Proportioning valve is controlled by time.
Purge Time - The time in seconds that the purge valve will open to purge the
convey line. (Purge time follows Load time).
Priority - Sets the order of importance of the receivers. Setting
a receiver to level 1 sets to the highest priority, while setting to
level 5 sets to the lowest priority. Higher priority receivers
receive material first while lower priority receivers receive
material later.
Layering Proportioning valve - This symbol represents the Virgin (Natural) /
Regrind % material layering on the input side of the receiver.
Purge - This symbol represents the purge valve. When purging, the
symbol will show a blue arrow.
The Receiver's label and defaults can be reset by touching the large receiver
image in the center of the screen.
Press the info button to display the ID Number, Serial Number, firmware and the
label of the loader. From this screen the loaders label can be set or changed.
If info button is not displayed, press the image of the pump.