Maguire Products FLEXBUS, Instruction Manual

Page: 9 / 29

M A G U I R E P R O D U C T S , I N C .
9
M A G U I R E

FLEXBUS™
Pump Assignment -
Pumps must be assigned before Receivers.
Flexbus Lite (part of the Maguire 4088 TS Weigh Scale Blender) controls a single pump. The
Flexbus System can control of to 5 pumps. If you have two or more pumps (Flexbus only), turn
OFF all pumps prior to running Setup in the Flexbus controller, otherwise: To assign Pumps,
follow these instructions:
On the
HOME
screen,
PRESS:
Pressing the SETUP button prompts for a password.
PRESS:
22222
Enter the password (default password is 22222)
Press
to confirm password.
This enters the Setup screen. This screen contains several setup specific options.
To setup
Pumps:
PRESS:
Press the large Pumps button on the far left of the
screen.
This enters the PUMP assignment screen. This gray screen contains any previously assigned
pumps. For first time setup, this screen is probably blank and no pumps have been assigned.
At this time, turn on your Flexbus Pumps in the order that you want then to be assigned.
If you have a single pump, that pump
will appear on the screen and be
labeled with the number 1. If you
have multiple pumps, they will
appear on the screen and be
numbered in the order that they were
turned on. Pressing the pump icon
will allow you to re-assign the ID
number to a different unassigned
number.
PRESS:
To return to the Setup screen. When you return to the
Setup screen, the Pumps button will show the Setup
symbol
on the Pumps button indicating that you are
still in the Pump Assignment mode.
PRESS:
To Exit the Pump Assignment Mode . Setup icon
overlaying the button will disappear indicating you are
out of Pump assignment mode.