Section 6. 4777 Emulation Mode
41
Encoding data on track 1 2
Slide card left when ready
After encode (for at least 4 seconds):
Card encoded correctly
Follow PC screen instructions
After encode (and host has responded, even if card still in slot):
<Idle
Top>
<Idle
Bottom>
After encode command issued with card at right side but card not swiped within 20 seconds:
Timeout waiting for card to be swiped
Remove the card
(In this case, the operation can continue when the card is inserted back into the slot.)
After a bad encode (continues forever until good encode or card removed):
Did not encode properly. Try again.
Slide card right when ready.
After an attempt to encode on a HiCo card when unit is set to Auto:
This may be a HiCo card. Try again.
Slide the card right when ready.
Summary of Contents for MT-95
