MT-95 RS-232 HiCo/LoCo Encoder/Reader
38
Please wait during system self test
Then the following will appear:
Mag-Tek MT-95
P/N: 30060819
Rev:J07
S)etup
5. Select
S
etup from the menu, and the following will appear:
Select option to change
Esc=exit
I)dle Display E)ncode Energy
C)ard Time
6. From the option menu, select
E
ncode to specify the encode energy level (
H
iCo,
L
oCo, or
A
uto detection). Press
Enter
when done.
7. Turn the power off.
8. Disconnect the keyboard.
9. Connect the communication cable.
MODIFYING IDLE MESSAGE ON MT-95
The 2-line idle message, i.e., the message that is shown when no command has been issued, can
be specified by the user. Up to 40 characters can be placed on each line. Follow the directions
below to change the idle message.
1. Turn off power switch on MT-95.
2. Disconnect the communication cable.
3. Attach an AT-style keyboard.
4. Turn on the power switch.
The following will appear briefly on the LCD:
Please wait during system self test
Then the following will appear:
Mag-Tek MT-95
P/N: 30060819
Rev:J07
S)etup
5. Select
S
etup from the menu, and the following will appear:
Summary of Contents for MT-95
