Section 3. Standalone Operation
17
If a card is swiped before the unit is ready to encode, the following will appear:
* Card was swiped before encoder ready *
->Slide card right when ready->
Other messages that may appear are as follows:
Cannot encode card (check orientation)
The card may be inserted upside down. Ensure the stripe is facing down and parallel to the slot.
No data to encode
At least one card must contain data before a card can be encoded.
Track 1 is too long.
Too much data has been entered on a track. This applies to Track 2 and 3 as well. This can only
occur when operating online.
This is not a valid Format Card
Ensure Format Card is used. It must have variable data entries.
Only ISO encoded cards can be copied.
Cards in other formats cannot be copied (a driver license, for example).
Time elapsed. Remove card.
or
Timeout waiting for card to be swiped
A timeout occurred before the card was swiped.
Summary of Contents for MT-95
