3 - Command Set
DynaPro Mini| PIN Encryption Device | Programmer’s Manual (Commands)
Page 34 of 128 (
D99875629-43
)
3.4.5
Command 0x05 - Cancel Command
This command cancels the current command.
Table 3-5 - Usage Table for Command 0x05
Bit
7
6
5
4
3
2
1
0
Byte 0
0x05
Byte 1
0
3.4.6
Command 0x06 - Request Cardholder Selection
This command directs the device to prompt the cardholder to select the transaction type (debit, credit,
etc.) or to verify the transaction amount, as shown below.
Figure 3-4 - DynaPro Mini "Amount OK" Cardholder Selection Screen
If an error occurs, the device will terminate the command and report the error in ACKSTS of
. For a full list of error codes, see
Appendix C Status and Message Table, Table
After the cardholder makes a selection or cancels, or if a timeout occurs based on Wait Time, the device
will do the following:
1)
Clear the display
2)
Return to the idle state
3)
Report 0x25 - Cardholder Selection Response Report
Table 3-6 - Usage Table for Command 0x06
Bit
7
6
5
4
3
2
1
0
Byte 0
0x06
Byte 1
Wait Time in seconds, (1 - 255; 0 = 256 seconds)
Byte 2
Message ID:
0 = Transaction type
Credit / Debit
1 = Verify Transaction Amount
2 = Transaction type
Credit / Other / Debit
3 = Transaction type
Credit / EBT / Debit
4 = Transaction type
Credit / Gift/ Debit
5 = Transaction type
EBT / Gift / Other
Byte 3
Mask Key:
Enter
Right
Middle
Left
