3 - Command Set
DynaPro Mini| PIN Encryption Device | Programmer’s Manual (Commands)
Page 31 of 128 (
D99875629-43
)
Figure 3-2 - DynaPro Mini Initial Swipe Prompt
If an error occurs, the device will terminate the command and report the error in ACKSTS of
. For a full list of error codes, see
Appendix C Status and Message Table, Table
When this command completes (card swiped OK, cardholder or operator cancelled, or timeout), the
device will send
Report 0x22 - Card Status Report
to the host. If the Card and Operation Status are
both OK, the host should then send
Command 0x0A - Request MSR Data
For an example of using this command, see
Appendix A.1 How to Get MSR/PIN Data from the Device
Table 3-3 - Usage Table for Command 0x03
Bit
7
6
5
4
3
2
1
0
Byte 0
0x03
Byte 1
Wait time in seconds, (1 - 255; 0 = infinite wait time)
Byte 2
Card Message ID to display:
0 = Swipe Card / Idle alternating
1 = Swipe Card
2 = Please Swipe Card
3 = Please Swipe Card Again
4 = Chip Error, Use Mag Stripe
Byte 3
Tones:
0 = No sound
1 = One beep
2 = Two beeps