Appendix I - Bluetooth LE Module Control Data (Bluetooth LE Only)
DynaPro Mini| PIN Encryption Device | Programmer’s Manual (Commands)
Page 121 of 128 (
D99875629-43
)
(0x00). If set to a length of 0 the value will revert back to its original default value described above.
After modifying the Bluetooth device name, you must reset the Bluetooth LE module. See section
How to Use Bluetooth LE Connections
Example Get Bluetooth Device Name property:
Request message (hex): 00 00 02
Response message (hex): 01 00 31 32 33 (device name “123”)
Example Set Bluetooth Device Name property:
Request message (hex): 00 01 02 31 32 33 (device name “123”)
Response message (hex): 01 00
I.1.6
Configuration Revision Property
Property ID: 0x03
Get Property: Yes
Set Property: Yes
Non-Volatile: Yes. Changes made to this property will persist even if the device is powered off or reset.
This property should only be changed once during device configuration. Modifying this property too
many times will wear out flash memory.
Default value: 0
Description: This property contains the configuration revision. The configuration revision can be used by
the host to determine if the Bluetooth LE module’s non-volatile properties have been configured and if so
to what revision they have been configured to. For example, after the host configures the Bluetooth LE
module’s non-volatile properties to a certain state it may also want to bump this configuration revision to
1. Then the host can check this configuration revision on power up and use it to determine if the
Bluetooth LE module’s non-volatile properties have been configured to the desired state or not. For
example if the configuration revision is 0 then the module needs to be configured and if it is set to 1 then
it has already been configured to the desired configuration.
The Bluetooth LE module’s non-volatile properties are stored in flash memory so they should not be
changed too many times or the flash memory may wear out. This property is a one byte value that can be
set to any value between 0 and 255.
Example Get Configuration Revision property:
Request message (hex): 00 00 03
Response message (hex): 01 00 01 (configuration revision 1)
Example Set Configuration Revision property:
Request message (hex): 00 01 03 01 (configuration revision 1)
Response message (hex): 01 00
I.1.7
Power Timeout Property
Property ID: 0x04
Get Property: Yes
Set Property: Yes
Non-Volatile: Yes. Changes made to this property will persist even if the device is powered off or reset.
This property should only be changed once during device configuration. Modifying this property too
many times will wear out flash memory.
Default value: 60 seconds
