Emergency activation of the service mode:
1. Initial state: the system is disarmed.
2. Open the hood and leave it open.
3. Enter a full personal code (see "Entering a personal code) - the system will give 3
short sound signals.
4. Close the hood - the system will give 6 short sound signals and goes into the ser-
vice mode.
Emergency deactivation of the service mode:
1. Open the hood and leave it open.
2. Enter a full personal code (see "Entering a personal code) - the system will give
two short sound signals and exit the service mode.
3. Close the hood, in case of necessity.
Control in the service mode:
Button
–central door locking closing
Button
–central door locking opening (two stage)
Button
– supply of a short light signal (0.2 seconds)
Button
– code entry / remote control
Note!
System's LED indicator will light up for 5 seconds at each turn on and off the
ignition in the service mode.
Automatic transmission of voice and SMS messages
via GSM
If the system registers the activation of the first warning zones of impact, tilt, dis-
placement, movement, or an additional sensor - the system will alert surrounding by sup-
plying short sound signals.
If the system registers the activation of sensors of doors, hood, trunk, activation of the se-
cond or third zones of impact, tilt, displacement, movement or additional sensors, discharge or
disconnecting the battery, switching on the ignition or engine starting - the system will send
the corresponding SMS-messages to the pre-programmed phone numbers, and call the number
of the owner and told him about the events in voice mode.
After receiving a voice message, the vehicle owner will have to confirm its reception
by pressing the "asterisk" - the system will automatically break connection.
If the message reception is not confirmed by the owner - system organizes a call the
next programmed telephone number.
Total 3 numbers for voice messages can be programmed in the system and for each
number can be made 3 attempts to dial.
Note:
When receiving an alarm voice message, the vehicle owner may either con-
firm the reception by an "asterisk" or switch to the remote control mode of the system (lis-
ten to voice prompts).
M880
OPERATION MANUAL
19
Remote control of system state
If the system registers the activation of various sensors, as well as in the case of any
other dangerous situations - the system will send GSM-messages to the pre-programmed
phone numbers.
You can call to phone numbers of the system's SIM-card on your own initiative. The
system, depending on the access mode, or reset the call, or ask for a personal code, or im-
mediately begin to generate voice messages in a circle describing its current state and offer
to make a choice:
"To enable or disable the messages - press 0"
"To check the account - press 1"
"To send a SMS about the location of the vehicle - press 2"
"To send a MMS about the location of the vehicle - press 3"
"To send a SMS about the location of the vehicle by GPS - press 4" (optional)
"To send the service message – press 6"
"To enable the microphone - press 8"
"To enter the remote control mode – press "asterisk"
"To activate the program mode – press "grid"
Note 1:
Service message contains the name and model of the system, software ver-
sion, IMEI GSM-module, temperature of internal and external sensors, as well as the num-
ber of remote key fobs pre-programmed in the system.
Note 2:
In the listening mode of interior, button "7" of a phone reduces the sensitivi-
ty of the microphone, and button "9" - increases. Button "0" of a phone disables the listen-
ing mode.
System control via a phone
1. Call the SIM-card number the vehicle security system.
2. Enter a personal code in case of necessity.
3. Press the "asterisk" to switch to the remote control mode.
4. Perform the necessary actions following the voice prompts.
5. Break the connection at the end of the remote control session.
Warning!
Be careful when entering a personal code. In case of an error when enter-
ing the code, the system will break the connection and send to the phone of the owner SMS
containing the phone number from which is produced the wrong code entry.
In case of three errors when entering a personal code, the system will send SMS to
the vehicle owner about an attempt to code selection and block code entry for 1 hour. After
1 hour, the system unlocks the entry code for a single attempt, after 2 hours - for two at-
tempts, after 3 hours - for three attempts.
Unlock code entry is possible and ahead of schedule. For this purpose simply enter a
personal code via the ignition switch and LED indicator.
Note:
If the mistakes are made when entering the code from the phone of the car
owner, the SMS-message about errors are not sent.
OPERATION MANUAL
M880
20
