Switching off the sensors when arming
1. To switch off the warning zones of sensors is necessary no more than within 2 se-
conds after arming - press again the remote key fob button
.
2. To switch off the main zones of sensors is necessary no more than within 2 se-
conds after arming – double press the remote key fob button
.
Diagnostics of sensors when arming
If within 2 seconds after arming, the system submits one long sound signal - the hood
is open or hood sensor is defective.
If within 2 seconds after arming, the system submits 2 long sound signals - the door
is open or door sensors are defective.
If within 2 seconds after arming, the system submits three long sound signals - the
trunk is open or trunk sensor is defective.
If within 2 seconds after arming the system submits 6 short sound signals - the sys-
tem is out of reliable reception of GSM-network.
Note 1:
When you restore the normal state of sensors of doors, hood or trunk they
will be automatically switched to the security system.
Note 2:
In the case during arming interior lighting is switched off with a delay and
block the door sensors - the delay time of sensors diagnostic can be increased by program-
ming. Maximum time is 60 seconds.
Delayed arming of the system
"Delayed arming" function is off in the factory setting. Delayed arming is needed in
cases when you want to pick up heavy, awkward or bulky items from the vehicle:
1. Switch off ignition.
2. Open the driver's door.
3. Briefly press the remote key fob button
- timer of delayed arming will be start-
ed: system LED will blink with a frequency of 4 flashes per second.
4. In case of necessity, no more than within two seconds after the first press of the
button
, press it even 1 or 2 times to switch off the sensors (see "Switching off the sen-
sors when arming").
5. Close the driver's door and, if necessary, no more than within 10 seconds open the
other doors or trunk (can be opened in advance).
6. Close all doors and trunk - after 10 seconds the system will give 1 sound and 1
light signal, close all door locks and go into the armed mode.
Note 1:
When the timer expires, and when you press again the button
, the system
will go into armed mode even at the opened doors or the trunk. When closing the doors and
trunk, they will be automatically switched to the security system.
Note 2:
To cancel the delayed arming press the button
,
or
of the remote key
fob or switch on the ignition until the end of timer work.
M880
OPERATION MANUAL
5
Arming via a phone
1. Park your vehicle and stop the engine.
2. Leave the vehicle and close all doors, hood and trunk.
3. Call the SIM-card number of the vehicle security system.
4. Enter a personal code in case of necessity.
5. Press the "asterisk" to switch to the remote control mode.
6. Press the button "1" of a phone - the system will arm.
7. In case of necessity switch off the sensor's zones - press button "8".
8. Break the connection (see "Control via a phone").
Note 1:
When controlling the security system via a mobile phone - listen to the
voice prompts.
Note 2:
In the case when arming the doors, hood or trunk will be unclosed - the sys-
tem will notify by a phone.
Arming of the vehicle with a turbine
When arming the vehicle with a turbocharged engine is necessary to provide capabil-
ity of its work during certain period of time without a key in the ignition. For this purpose
the installer should arrange hardware support of ignition and perform the necessary set-
tings.
Arming
1. Turn on parking or parking brake with the engine running - temporary support of
ignition will be activated - system's LED will blink with a frequency of 4 flashes per se-
cond
2. Remove the key from the ignition - the engine will continue to run.
3. Leave the vehicle and close all doors and trunk.
4. Press the remote key fob button
- the system will give 1 sound and 1 light sig-
nal, close all door locks and go into the armed mode with the engine running.
5. After the programmed time (in the factory setting is 5 minutes) - the engine will be
turned off and the system will go into the armed mode.
Note 1:
Turn-off delay of the engine can be programmed in a fairly wide range -
from 0 to 30 minutes. Before the end of the turn-off delay time, the system via a phone, can
be converted into the standard armed mode or returned to the mode of further operation of
the vehicle (see "Security with the engine running").
Note 2:
If the car is not turbocharged or cooling of the turbine is not mandatory, the
installer can implement a controlled enabling of ignition support for to put the system into
the armed mode with the engine running. This mode will allow leaving a vehicle with the
engine running for a while without a key in the ignition.
OPERATION MANUAL
M880
6