Automatic engine starting
Automatic engine starting is possible only in armed mode. For vehicles with manual
transmission and not turbocharged engine automatic engine starting is possible only after
arming with reservation of engine starting (see "Reservation of engine starting").
Engine starting by temperature of the engine
The system provides the possibility of organizing an automatic engine starting for its
warm-up during the cold season. The installer should mount the special temperature sensor
on the cylinder block and to program the lower temperature threshold for the engine start-
ing for this function implementation.
Recommended time of engine operation for its warm-up is 20 - 30 minutes.
Note:
Automatic engine starting by temperature is not programmed in the factory
settings of the system.
Engine starting by interior vehicle temperature
The system provides the possibility of organizing an automatic starting the engine to
warm-up of interior in the cold season and for cooling in summer. The installer should fix
the special temperature sensor in the interior vehicle and to program as the lower and upper
thresholds of interior temperature for the engine starting for this function implementation.
Note 1:
If the external temperature sensor is not connected, engine starting will be
carried out by the built-in temperature sensor of the system.
Note 2:
Automatic engine starting by interior vehicle temperature is not programmed
in the factory settings of the system.
Engine starting for battery charging
Possibility of sending voice and SMS-messages about discharge of the car battery is
provided in the armed mode. The threshold of the battery voltage must be programmed to
implement the sending of these messages.
The recommended threshold for sending messages about low battery is 11,75V.
The system also provides the possibility of organizing of automatic engine starts to
recharge the regular car battery. The lower threshold of battery voltage for engine starting
must be programmed to implement such engine starts.
The recommended threshold for automatic engine start is 12,25V.
By lowering this threshold residual battery capacity may be insufficient for reliable
starting engine, and with increasing this threshold - will be significantly increased the fre-
quency of engine starts to recharge the battery.
Recommended time of engine operation for battery charging is 20 - 30 minutes.
Note:
Sending messages about low battery and engine starting to recharge the bat-
tery is not programmed in the factory settings.
M880
OPERATION MANUAL
15
Security with the engine running
In the case of automatic or remote start of the engine, as well as in the case of activa-
tion of "Delay of engine stalling" function, the system will be in a special mode of opera-
tion "Security with the engine running".
This mode provides automatic support for the ignition in the turned on state without a
mechanical or electronic key in the lock.
Central door locking, door and trunk can be opened and closed without disarming the
system and engine stalling by means of the remote key fob or the phone.
Especially for the security mode with the engine running there are additional, third
zones of impact, tilt, displacement and motion sensors.
At activation of the third zones of sensors, at unauthorized opening of the doors,
hood, trunk, or when you turn off the parking brake (parking) - the engine will be instantly
switched off, the alarm will be turned on, as well as the corresponding voice and SMS-
messages will be sent, and the system goes into the regular armed mode.
In the case of software and hardware implementation of the relevant functions, the
engine is switched off at heating above 110 degrees, at dangerous increase of the idle speed
and at emergency drop of oil pressure.
The system can be in the armed mode with the engine running for a time, pre-
programmed by the installer.
After the set time the engine will be turned off, the system will give 1 sound and 1
light signal and switch to the normal armed mode.
The system can be switched from the security mode with the engine running into the
armed mode or returned to the vehicle operation mode at any time.
Transition of the system to the armed mode via a remote key fob
Press and hold the remote key fob button for one second
- the system will give
short sound signal, switch off the engine and goes into the normal armed mode
Transition of the system to the armed mode via a phone
1. Call the SIM-card number the vehicle security system.
2. Enter a personal code in case of necessity.
3. Press the "asterisk" to switch to the remote control mode.
4. Press button "4" of a phone to turn off the engine.
5. Break the connection (see "System control via a phone").
Transition into vehicle operation via a remote key fob
1. Press the remote key fob button
to open the central door locking - system's
LED will start flashing with a frequency of 4 flashes per second.
2. Not later than 30 seconds - open the driver's door.
3. Insert the key into the ignition and turn it to "On" position.
4. Switch off the parking (parking brake) or click the remote key fob button, while
holding
- support of ignition is turned off and the system's LED turns off.
OPERATION MANUAL
M880
16
