![background image](http://html1.mh-extra.com/html/magnetek/telemotive-tr12-intelesmart/telemotive-tr12-intelesmart_instruction-manual_3587676049.webp)
Section 7 - Programming (continued)
Telemotive TR12 inteleSmart Receiver Instruction Manual – 03/01/07
47
7-11.13. Tx Status Word S4-4. (Invert Crane Select
Outputs). Normally OFF.
Definition: This feature is only for custom crane relay
configurations using select relays. Turning this switch
ON (1) reverses the select function operation so that the
opposite relay closes for the selected function.
Programming:
Turn the Tx Status Word switch S4 position 4 ON (1) for
to invert the operation of the Select 1 and Select 2 relays.
With this switch ON (1) the “A” LED on the transmitter
activates Select relay 1 and the “B” LED activates Select
relay 2.
7-11.14.
Tx Status Word S4-7. (By Pass Status
Settings). Normally OFF.
Definition: This accommodates custom crane relay
configurations when you wish to keep the custom crane
relay configuration programming in the transmitter for
transmitter compatibility with older systems. (Disabling
and by passing receiver Tx Status switches S3-5 through
-8).
Programming:
Turn Tx Status Word switch S4 position 7 ON (1) and
transmitter will generate the same crane configuration on
this receiver as it does on the other crane. Refer to the
older receiver manual custom crane configuration and
look up the same crane configuration in this manual
Section 6 – Wiring to determine the appropriate relay
output in this receiver.
7-11.15. Tx Status Word S4-8. (User Configured).
Normally OFF.
Definition: This is advanced programming that allows,
through the PDA, custom output mapping of the relay
closing per transmitter button activation. This is to be
used only when the predefined custom crane
configurations do not meet the requirements. If not
familiar with this type of programming it might
recommended that you contact your Telemotive
representative.
Programming: Tx Status Word S4-8 Should be OFF
(0) except for custom crane relay mapping. Custom
relay mapping uses the boxes marked “Aux #” and
“Motor #” at the bottom of the “Receiver Programmer”.
These boxes become active when S4-8 is selected. See
Section 7-12. Using Custom Mapping for detailed
instructions on custom mapping.