Section 3 - General System Information
Telemotive TR12 inteleSmart Receiver Instruction Manual – 03/01/07
9
17. AK17
436.6 MHz
18. AK18
436.4 MHz
19. AK19
436.2 MHz
20. AK20 436.0 MHz
21. AKA00 433.125 MHz
22. AKA01 433.325 MHz
23. AKA02 433.525 MHz
24. AKA03 433.725 MHz
25. AKA04 433.925 MHz
26. AKA05 434.125 MHz
27. AKA06 434.325 MHz
28. AKA07 434.525 MHz
29. AKA08 434.725 MHz
30. AK38
432.4 MHz
31. AK50 430.0 MHz
3-1. General System Information.
The Telemotive Radio Control System (system)
provides remote control of overhead cranes using
radio signals. The system consists of a hand held
portable battery operated transmitter unit and a
fixed station receiver unit.
A unique 16-bit code (Access Code) for each
system is preset in every transmitter and receiver.
The receiver considers any received signal, which
does not match the receiver access code setting,
invalid. The Access Code is made up of 16-bits
(65,000 combinations) and no two similar codes are
assigned to any two Telemotive systems.
Up to four systems may be used with the same
frequency in a 600-foot area (220 meters). Each
transmitter operating on the same frequency may be
operated in close proximity, not less than six feet
(1.9 meters) to each other.
3-2. TMS Low Power Signaling.
TMS (Time Multiplexed Signaling) is a Telemotive
proprietary high-speed packet data system. The
system software is structured to minimize "on the
air" transmission time of any transmitter. This
allows for multiple transmitters to share a common
frequency. The TMS system is designed so that a
transmitter will send a signal for a predetermined
ON time, and then will turn OFF. The length of
transmitter ON time is referred to as data burst or
packet. The packet length is a function of the
quantity of data to be sent, and the data rate (baud).
Once the packet is sent, the transmitter will turn
OFF. This allows for other transmitters to time-
share the same frequency when a transmitter has
turned OFF. The TMS system software determines
the OFF period and repetition rate of the ON
period. Since each system has its own access code,
up to 4 transmitters can share and have equal access
to the same frequency. TMS also allows for
reduced battery consumption and extended battery
life.
These systems have low power pulsed signaling,
FCC certified under Part 15 Telecommunications
Code of Regulations, no license is required. The
transmitter unit is frequency modulated, low power
and is certified under the appropriate regulations. A
license is not required for the transmitter or
operator. Modifications to the RF section of this
system are not permitted and could void FCC
certification.
3-3. Channel Designations:
3-4. Receiver Specifications.
Receiver housing: NEMA 4X, IP67
Operating Temperature: –22° F to +158° F (-30
degrees C to +70 degrees C) ambient.
Humidity: up to 95 % (non-condensing).
Typical Operating Range: 300 feet (91 meters).
Relays are rated for 16 Amps 277VAC/24VDC, 1
HP 240VAC for maximum life and surge
protection, they are fused with 2AG Slow Blo fuses
and protected with MOV’s.
3-5. Receiver Unit.
The receiver unit consists of a synthesized RF
module, antenna, integral power supply,
microprocessor controlled output motor control and
auxiliary function relays and mainline contactor
relay. The receiver unit contains circuitry, which
matches the frequency and access code of the
transmitter.
01. AK01 439.8 MHz
02. AK02 439.6 MHz
03. AK03 439.4 MHz
04. AK04 439.2 MHz
05. AK05 439.0 MHz
06. AK06 438.8 MHz
07. AK07 438.6 MHz
08. AK08 438.4 MHz
09. AK09 438.2 MHz
10. AK10 438.0 MHz
11. AK11 437.8 MHz
12. AK12 437.6 MHz
13. AK13 437.4 MHz
14. AK14 437.2 MHz
15. AK15 437.0 MHz
16. AK16 436.8 MHz
Indicator Channel Actual
Count Designator Frequency
Indicator Channel Actual
Count
Designator
Frequency