Magnetek Telemotive TR12 inteleSmart, Instruction Manual

Page: 53 / 60

Section 7 - Programming (continued)
Telemotive TR12 inteleSmart Receiver Instruction Manual – 03/01/07
51
7-13. Access Codes.
7-13.1. Access Code Programming.
The access code is set at the factory and should not be
changed unless absolutely necessary. The programming
in the receiver(s) must match the transmitter. If you are
reprogramming a spare or new transmitter make sure the
other transmitter is securely taken out of service.
For detailed instructions on setting Access Codes see
Section 7-7. Programming Access Code.
After changing the access code, test the receiver with a
matching transmitter. (If the red LED DS6 comes ON in
the receiver the code does not match. Recheck the access
code settings).
WARNING
THE ACCESS CODES IN THE RECEIVER ARE
UNIQUE AND FACTORY PRESET. DO NOT
CHANGE THESE ACCESS CODES UNLESS YOU
ARE REPLACING AN EXISTING RECEIVER AND
ITS ACCESS CODE. CHANGING THIS CODE
COULD MAKE IT COMMON WITH ANOTHER
RECEIVER ACCESS CODE, WHICH COULD MOVE
ANOTHER CRANE. NO TWO SYSTEMS IN ANY
LOCATION SHOULD EVER HAVE THE SAME
ACCESS CODES INDEPENDENT OF FREQUENCY.
TWO OPERATIONAL TRANSMITTERS WITH THE
SAME ACCESS CODES OPERATING AT THE
SAME TIME IS A DEFINITE SAFETY HAZARD.
AFTER CHANGING THE ACCESS CODES, TEST
THE TRANSMITTER BY TURNING IT ON AND
OFF NEAR THE RECEIVER. IF THE RECEIVER
DOES NOT RESPOND, DO NOT ACTIVATE A
FUNCTION BUTTON! THE TRANSMITTER MAY
HAVE THE WRONG ACCESS CODE, WHICH
COULD MOVE ANOTHER CRANE. RE-CHECK
THE ACCESS CODE AND RETEST.
FAILURE TO FOLLOW THESE WARNINGS
COULD RESULT IN SERIOUS INJURY OR DEATH
AND DAMAGE TO EQUIPMENT.
Figure 7-13. Access Code Setting.
(A dot on a switch position or a “1” in the
label is an indication that the respective
switch position should be ON).
Sample Membrane or Pendant Transmitter
Access Code Label
Sample access code only do not use
SW1
Membrane
Transmitter
Pendant Transmitter
SW1
OFF
1 A
8
ON
OFF
ON
8 B 1
MODEL # -10KXXXXXXXX
S/N=XXXXXXXXXXXXXXXXX
ACCESS CODE SETTING
1 A 8 1 B 8
0 1 0 0 0 1 1 1 0 1 1 0 0 0 1 0
FREQ: = AK01 J # = XXXXX
ON
SW2
OFF 8 A 1
1 B 8
OFF
ON
SW2
OFF
A1
Transmitter or
Receiver PDA
1 A 8
ON
OFF
1 B 8
ON
OFF
B1
Receiver access code
1
0 1
0
Indicates switch in OFF position