![background image](http://html1.mh-extra.com/html/magnetek/electrobar-fs/electrobar-fs_instruction-manual_3572977007.webp)
Electrification FS Conductor Bar System Instruction Manual
October 2019
Page
7
of
34
DANGER
HIGH VOLTAGES ARE PRESENT IN THE CONTROL PANEL, ELECTRICAL COMPONENTS, AND
THE CONNECTION BETWEEN THESE COMPONENTS.
Before installing, servicing, or inspecting any electrical or mechanical components of this power
equipment, power must be disconnected at the source and proper lockout/tagout procedures followed.
DO NOT make or break electrical connections (example, plugs and receptacles) without first
disconnecting power at the source and following proper lockout/tagout procedures.
REFER TO ANSI Z244.1 PERSONNEL PROTECTION - LOCKOUT/TAGOUT OF ENERGY SOURCES.
Only qualified personnel should install components, inspect, and/or service this equipment.
Many tests and procedures outlined in this manual involve exposure to components that operate
at potentially lethal voltage levels. To eliminate this hazard, service personnel must ensure that
the incoming three-phase AC power has been disconnected, locked out and tagged.
Chapter 5: JOINT ASSEMBLY – Danger, Warnings and Cautions
Standard Joint Covers are shipped with foam packaging located on the inside of the joint cover.
Please remove prior to assembly.
©2015 MAGNETEK
All rights reserved. This notice applies to all copyrighted materials included with this product, including,
but not limited to, this manual and software embodied within the product. This manual is intended for the
sole use of the persons to whom it was provided, and any unauthorized distribution of the manual or
dispersal of its contents is strictly forbidden. This manual may not be reproduced in whole or in part by
any means whatsoever without the expressed written permission of Magnetek.