![background image](http://html1.mh-extra.com/html/magnetek/electrobar-fs/electrobar-fs_instruction-manual_3572977026.webp)
Electrification FS Conductor Bar System Instruction Manual
October 2019
Page
26
of
34
8.3:
250/400 Amp In-Line Power Feed Assembly (FS-PFC)
8.3.(a):
Remove both nuts on the top side of the power feed base (joint connector). Verify that
the clamping plate is 1/8” below the underside of the joint assembly bracket.
8.3.(b):
Slide the joint assembly into the upper slot of the end of the line element. Be sure the
clamping plate is properly located in the end of the line element.
8.3.(c):
Slide the next line element into the open end of the joint assembly. Be sure the clamping
plate is properly located in the end of the line element.
8.3.(d):
Center joint assembly over the adjoining line elements.
8.3.(e):
Slide the power feed bracket over the stud to the power feed base (joint connector) and
thread the nuts to the threaded studs.
8.3.(f):
Tighten one nut of the power feed base (joint assembly 55 in-lb.).
8.3.(g):
Verify the end face of each line element is together.
8.3.(h):
Tighten the other nut of the power feed base (joint assembly 55 in-lb.).
8.3.(i):
Assemble power feed wire to one lug of the power feed bracket using an appropriate
terminal connector.
8.3.(j):
Assemble nut to power feed bracket carriage bolt and tighten 26 to 33 ft-lb. (312 to 396
in-lb.).
8.3.(k):
Slide the power feed cover half up from the bottom of the conductor bar. Pull up on the
power feed cover half so the lower lips are in contact with the bottom of the line element cover
and insulate the vertical face of the exposed conductor bar.
8.3.(l):
Repeat with the other half. Align cable with cable opening on appropriate side of power
feed cover.
8.3.(m):
Insert the four cover screws and tighten.
8.3.(n):
Attach wire ties over each end of power feed cover and tighten-remove excess.
8.3.(o):
Insert red power feed cover plug into end of cover without cable.
NOTE: Tools Required:
3/8” Wrench or Socket
9/16” Wrench or Socket
Flat
Head
Screwdriver
(small)
NOTE: A liberal coating of joint compound, FS-JNJC, is recommended on all mating faces that conduct
current.
NOTE: To use in-line power feed as end-line power feed assembly, see page 28 for instructions.