Magnescale SR138-025R, Instruction Manual

Page: 68 / 180

16 (E)
English
(3) When the slider mounting surface has yet to meet
the specifications
When the mounting surface of the machine is a casting
surface, use a bracket.
Place the bracket on the underside of the slider part without
loosening the screws that hold the slider holder. Adjust the
position of the bracket and mount it with the supplied
M4
×
12 bolts.
Fig. 3-9
B C
42±0.2/1.65"±0.008"
8.7 to 8.8/0.34" to 0.35"
Fig. 3-10
Slider holder
Scale part
2-Plain washers
(small)
4t to 6t/0.16" to 0.24"
17/0.67" or less
Mounting bracket
Slider part
[When the supplied spacers (t=0.1 mm
×
5) are
unable to fill the gaps between the mounting
surface and the slider part]
Loosen the screws securing the slider part of the slider
holder, press the slider part against the scale part, and tighten
the bolts in this condition.
(2) When the gap between the B and C surfaces is set
to exactly 9 mm/0.35"
Loosen the screws securing the slider holder and move the
slider part by hand to align it with the brackets. Then secure
the slider part at the position of 42±0.2 mm/1.65"±0.008" as
shown in Fig. 3-9. Spacers are not required.
Note
Do not attempt to move the bracket side with the slider
holder secured, as the brackets may strike the slider part.
2-M4
×
12
(accessory)