9 (E)
3.
A new tab will open. After the tab opens, it appears as shown below. Check that
“Navigation Area” is “Controller Network Settings”. The “Network Settings”
displayed here are the settings for X20IF10E1-1.
Fig 4-8
Automation Studio -- Setting the IP address and the device name (main unit
side) -- No.3
4.
Set “IP address” and “Network mask” of X20IF10E1-1 to the desired values (the
values to be used with the actual network), and click “Apply”.
* In the example in this manual, “IP address” is set to “192.168.0.20” and
“Network mask” is set to “255.255.255.0”.
When using a router, set “Gateway address” to the IP address of the router.
Fig 4-9
Automation Studio -- Setting the IP address and the device name (main unit
side) -- No.4
5.
Select “Ethernet Devices” from “Navigation Area”.
At this point, the Ethernet devices present on the development computer will be
displayed in the “Use Network Connections for Scan” list.
Fig 4-10
Automation Studio -- Setting the IP address and the device name (main unit
side) -- No.5
6.
Place check marks in the “Device” checkboxes of the Ethernet devices connected
to the X20BC00E3.
