29
CHANGING FROM A BELT TO
A GRINDING WHEEL
Be sure the MAG-8200 power cord is unplugged. Remove the front steel grinding wheel cover
by releasing the two catch clamps on each side of the grinding cavity. Use the crank handle to
raise up the contact wheel. The idler pulley will get closer to the contact wheel as you turn the
crank handle. This will take the tension off the abrasive belt and allow it to slide off easily.
Scan the QR code to watch a how-to-video.
1.
Remove the abrasive belt.
2.
Remove the contact wheel in the same manner you remove a grinding wheel.
3.
Lower the crank handle to take all the tension off of the two springs below the idler pulley.
4.
Unhook the two springs from the idler pulley assembly.
5. Thread the eyelet tool into the hole above the idler pulley.
6. Pull the idler pulley assembly out.
7. Install the grinding wheel.
CAUTION
TURN OFF
AND UNPLUG
BEFORE SERVICING!
