Page 39
4.2.6.
Replacing the Receiver (Total Control)
1. Pull out the receiver from under the fire
and remove the batteries.
2. Gently pull out the HT lead and the valve
cable from the receiver (see
.
3. Unscrew and remove the SW and TC
connections.
4. Refit in reverse order. (The valve cable
plug fits into the receiver in one way
only).
5. Replace the batteries and return the
receiver under the heat shield.
4.2.7.
Programming Handset to Receiver (Total Control)
If for some reason the remote handset
requires re-programming to operate the
receiver follow the procedure below:
1. Press and hold, using a pointed object,
the receiver’s reset button until you hear
two acoustic signals (see
2. After the second longer acoustic signal,
release the reset button and within the
subsequent 20 seconds, press the
(small flame) on the remote handset until
you hear an additional long acoustic
signal confirming the new code is set.
RESET
Figure 46
