Page 9
2.4. Fitting the Trim
1. Most trims are coated with a
protective film. This must be
removed by peeling off before fitting
the trim.
2. Hook the outlet fascia plate at the top
of the glass frame (see
3. The trim is held on by four magnets.
These will either be attached to the
trim or supplied loose in a separate
envelope. Attach them to the four
brackets on the side flanges of the
fire as in
4. Offer the trim onto the flange of the
firebox. The magnets will hold the
trim in position.
5. Centralise the trim as necessary.
O u tle t F a s c ia
P la te
s e c tio n
Figure 13
M agnets
Figure 14
2.5. Home Improvements
NOTICE: Discolouration of wall surfaces
Generally, heating appliances will create warm air convection currents that will
transfer heat to any wall surface against which they are located.
Some soft furnishings (including blown vinyl wallpapers) may not be suitable for
use where they are likely to encounter temperatures above the normal room
level. For this reason, the manufacturer’s advice should be sought before using
this type of wall covering adjacent to any heating appliance.
The likelihood of wall staining caused from convected air currents will be
increased in areas where high levels of tobacco smoke or other contaminants
exist.
