Page 30
3.9.9.
Continuation of Installation - Total Control
1. Unpack the box containing the Receiver
and the Hand Set.
2. Fit four AA (1.5V) batteries into the
receiver unit and the PP3 (9V) battery
into the transmitter (hand set).
3. Connect the cables from the valve to the
receiver as shown in
Figure 37
keeping
the cables clear of the underside of the
tray. Does not force the valve cable plug
when inserting into the receiver – it only
fits one way.
4. Connect the HT lead to the receiver
5. Test the operation of the drive motor
using the hand set as per Users
Instructions (
on page
6. Fold the heat shield as per folding
instructions supplied and position it over
the receiver.
HT
Lead
SW
)
(yellow
TC
(
)
red
Valve
Cable
Figure 37
