With someone’s help, carefully lift
and place the -01 assembly on to the
cabinet assembly. Line the faceplate
up with the two pins coming out of
the -70s.
Carefully install/lift the -01 to
avoid dinging the Q7-57 (bottom
plate). Alex + sealant should squirt
out the sides between the -01 and
cabinet assembly.
Use (94) ¼-20 1” fasteners with red
Loctite to fasten the -01 to the cabinet
assembly.
Once fasteners are on and the -01 is
fastened to the cabinet, take your
ratchet with 3/16 bit and hand
torque all 94 fasteners again.
“Beard” the midrange ring-to do this
you will apply a layer of sealant to the
inside face of the midrange ring and
stick a very fine layer of BH Stuff to it.
44 |
P a g e
Summary of Contents for Q7
