60
10. After entering the fourth number, lights will flash to confirm acceptation of the
programmed code.
7.3. Disarming (using security code)
11. Knock on RPS 10 times.
12. At each knock LED will flash red once. Intervals between each
knocks must not be longer than 1.5 sec.
13. LED will start flashing blue fast.
14. Enter your 4-digit code by knocking correspondent number
between
1-9. After each knock LED will flash red once. Intervals
between
each knocks must not be longer than 1,5 sec. After entering
each
digit, wait until LED confirms the number by a corresponding
number
of blue LED flashes. If LED confirms the correct knock number
and
starts flashing quickly again, continue by entering remaining three digits. If there is a
wrong number entered, the remote control will start beeping and vibrating (4x). Then
go back to step 1.
15. After entering the correct code the doors will unlock, the car alarm will disarm which will
be displayed on remote, too.
If you enter the wrong password more than 5 times within 30 min, this function will
not be available for 24 hours or until the car is unlocked by the remote control.
ATTENTION !
The alarm has default security code 1111. The code we recommend you set up
immediately after taking the car!
7.4. Remote options set-up
+
———
Using the remote control you can set-
up basic user’s functions:
Keep buttons
and
pressed at the same time.
Button control procedures:
Function
Button
Present time set-up
Hours
Minutes
B
ac
k t
o
the
p
revi
ou
s
m
en
u
To
t
he
ne
xt
menu
Set-up of timer start reservation time
Hours
Minutes
Alarm clock set-up
Hours
Minutes
Alarm clock on/off
Change
Basic set-up :cancellation
RPS Set-up/cancellation
Change
Basic set-up :cancellation
Vibrating mode set-up /cancellation
Change
Basic set-up :cancellation
Change of the temperature unit
Change
–Basic set-up : °F
Change °F or °C
You will finish programming by pressing buttons
and
for more than 2 seconds.
