59
6.2. Valet mode deactivation
You can deactivate valet mode only by using the remote control:
Push buttons
and
shortly at the same time for 2 seconds.
Siren will beep once and lights will flash twice.
7. Programming
7.1. Remote control programming
System memory is designed for 3 remote controls. We recommend programming the remote
controls at professional installation service stations.
9. Alarm is disarmed.
10. Long press START button Lights will flash once. You are in valet / programming mode.
11. Within 6
seconds press button
on your remote control shortly. Lights will flash once to
confirm programming
.
On the programmed remote will show title „Id LEARN“.
12. The same way as in step 2, set the remaining remote controls. Lights will flash once to
confirm each remote. System will automatically exit the programming mode after the third
remote is set up or after 6 sec. time, which will be signalled by two flashes of the lights.
When programming new remote controls, old ones will be automatically erased. If
you have only one remote, it is not necessary to program it 3 times.
In case of losing or damaging your remote control...
If the alarm is armed and you have lost or damaged your remote, you can still open and
disarm the car by entering a four-digit code via RPS.
7.2. Setup of security code
For using 4 - digit security code as a code to emergency unlock, is necessary to enable this
option in the Program menu 1-04. The default code is 1111.
Setup of security code (1111-9999):
1. Ignition on.
2. Open the door.
3. Push the button on RPS sensor 10 times. At every single push, LED will flash red.
Intervals in-between the pushes must not be longer than 1.5 sec.
4.
LED will start flashing fast blue. If this is not happening, go back to step 1
.
5. Push the button on RPS as many times as your first number between 1-9 is. After each
push, red LED will flash.
6. After entering the digit, wait until led will confirm the digit by a corresponding number of
blue LED flashes.
7. Blue LED will begin flashing fast. Push the button on RPS as many times as your
second number between 1-9 is. After each push, red LED will flash once.
8. After entering the digit, wait until led will confirm the digit by a corresponding number of
blue LED flashes.
9. Repeat steps 7, 8 for entering the third and fourth number of your code.
