SIGMA LASER STENT AND TUBE CUTTER
990-401
25
15.
Remove the processed parts.
16.
Close the parts catcher by firmly pushing the parts catcher end into the parts catcher while aligning
the alignment notches with the locking buttons.
17.
Rotate the parts catcher end to lock in
place verifying that the open top part of
the parts catcher basket is facing
upward.
18.
Load a new piece of tubing
19.
Make sure the tubing is visible on the screen under the laser nozzle
20.
Press start to again run the program
21.
Repeat until the number of required parts have been processed
NOTE:
Some companies or customers may require that a number of parts may be required to be
visually and dimensionally inspected after processing a given number of parts before cutting additional
parts.
Be sure to find out if this is a company requirement for the parts being processed.
