Mackie DL806 and DL1608 Reference Guide
111
Chapter 15: Mackie My Fader Software
Introduction
Do you want to control the mix via iPhone or iPod touch? OF course you do! Well, you’ve come to the right
place! At this point, you must be well-versed in – or at least
somewhat
familiar with – the ins and outs of
Master Fader. My Fader looks and works similarly to that of Master Fader, but just on a much smaller scale.
It’s great for easy, fast access to key controls needed during a show.
My Fader allows control of DL Series mixers via Wi-Fi from an iPhone 4, 4S, 5 and/or iPod touch (4th and
5th generation). Version 1.0 features touch-friendly control over multiple input channels at once and
an output selector for quick access to any mix. The addition of channel muting, detailed channel ID
and metering and the inclusion of a master fader provide unmatched control. Plus, an access control
feature limits users to only control their assigned output, keeping them away from other outputs.
This is great for simple on-stage control of monitor mixes. Also included is the ability to recall any
snapshots from the current show on the DL Series mixer. This way, bands are able to control the whole
mix from the stage. With My Fader, DL Series mixer users benefit from the full power of a digital mixer
with an easy-to-use application that fits right in their hand.
Downloading, Installing and Updating the My Fader App
The steps it takes to download, install and update the My Fader app are nearly identical to that
of the Master Fader app. Just follow the same steps as outlined in Chapter 5, starting on page 28
(but replace “Master Fader” with “My Fader”).
Using My Fader
My Fader doesn’t have
every single feature
of the Master Fader. Rather, My Fader contains the primary
features needed while a show is under way. You will still want to use Master Fader to set up everything
before-hand, then use My Fader to fine-tune levels and load shows during the set. There are three views
available on My Fader: mixer view, tools and shows.
Take a look at the mixer view of My Fader. Starting at the top and working your way down, the first thing
you might notice is that the whole top section of Master Fader is non-existent in My Fader; this includes the
entire navigation bar, channel EQ curves and GEQ. Also of note are the missing channel pans (and master
balance), as well as the solo and record buttons. Finally, whereas Master Fader displays nine faders at a time
(including the master fader), My Fader displays seven (including the master fader); trust me, you wouldn’t
want nine faders on My Fader...and I have skinny fingers!
The tools button is located above the output selector and shows may be accessed by touching the show
button located below the output selector.
