215981
84
Revision A
1018906
A
B
C
D
Figure 5.8: Hydraulic Center-Link
11.
If the hydraulic center-link self-alignment kit is installed:
adjust the position of center-link cylinder (A) until hook (B)
is above the header attachment pin.
12.
If the hydraulic center-link self-alignment kit is NOT
installed:
push down on the rod end of link cylinder (C)
until the hook engages and locks onto the header pin.
IMPORTANT:
Hook release (D) must be down to enable the self-locking
mechanism. If the release is open (up), manually push it
down after the hook engages the header pin.
13.
If the hydraulic center-link self-alignment kit is installed:
lower center-link (A) onto the header with the REEL DOWN
switch on the GSL until it locks into position and hook
release (D) is in the down position.
14.
If the hydraulic center-link self-alignment kit is installed:
check that the center-link is locked onto the header by
pressing the REEL UP switch on the GSL.
1014786
A
Figure 5.9: GSL
DANGER
Ensure that all bystanders have cleared the area.
15. Press HEADER UP switch (A) to raise the header to its
maximum height.
16. If one end of the header does
NOT
fully rise, rephase the
lift cylinders as follows:
a.
Press and hold HEADER UP switch (A) until both
cylinders stop moving.
b.
Continue to hold the switch for 3-4 seconds. The lift
cylinders are now phased.
NOTE:
Repeating this procedure might be necessary if there is air in
the hydraulic system.
17. Shut down the engine, and remove the key from
the ignition.
