215981
87
Revision A
1022842
A
B
C
Figure 5.16: HPT Display
27. Turn scroll knob (A) to highlight left float (B) or right
float (C). Press knob (A) to activate the selection.
28. Rotate scroll knob (A) to adjust the float setting. Press the
knob to confirm the selection.
IMPORTANT:
Adjusting the float by increments of 1.0 (out of 10) changes
the header weight at the cutterbar by approximately 91 kg
(200 lb.). Adjust the float in increments of 0.05 to fine-tune
the float setting.
29. Shut down the engine, and remove the key from
the ignition.
30. Grasp one end of the auger header and lift it. The lifting
force used should be 357 N (80 lbf). Repeat this step on the
other side of the header.
Connecting A40DX Auger Header Hydraulic and Electrical Systems
The header
’
s hydraulic and electrical multicoupler will need to be connected to the windrower.
CAUTION
Do NOT stand on an unlocked platform. It is unstable and may cause you to fall.
1015479
A
B
Figure 5.17: Left Cab-Forward Platform
1.
Approach platform (A) on the left cab-forward side of the
windrower. Ensure that the cab door is closed.
2.
Push latch (B) and pull platform (A) toward the walking
beam until it stops and the latch engages.
