215620
194
Revision A
$
%
&
Figure 5.165: Header Supports
13. Remove hairpin (B) from clevis pin (A). Remove the clevis
pin from header support (C) on each side of the header.
$
Figure 5.166: Center-Link
14.
Windrowers WITH center-link self-alignment kit:
Release
center-link latch (A).
$
Figure 5.167: Safety Prop Lever
15. Disengage the safety props on both lift cylinders as follows:
a.
Turn lever (A) away from the header to raise the safety
prop until the lever locks into the vertical position.
b.
Repeat the previous step for the opposite cylinder.
NOTE:
If the safety prop will
NOT
disengage, raise the header to
release the prop.
16. Repeat for the opposite side.
DANGER
Ensure that all bystanders have cleared the area.
17. Start the engine.
18. Remove the header float when prompted by the Harvest Performance Tracker (HPT).
NOTE:
If you are not prompted by the HPT to remove the float, remove the float manually.
19. Lower the header fully.
