UNLOADING AND ASSEMBLY
169001
Revision F
35
STEP 24. LUBRICATE MOWER
CONDITIONER
WARNING
To avoid bodily injury or death from
unexpected start-up or fall of raised
machine, stop engine, remove key and
engage safety props before going under
machine for any reason.
The mower conditioner has been lubricated at
the factory. However, lubrication of the mower
conditioner is recommended prior to delivery to
offset the effects of weather during outside
storage and transport, and to familiarize the
Dealer with the machine.
Refer to the following table and illustrations on
the following pages for lubrication points.
•
Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
•
Inject grease through fitting with grease gun
until grease overflows fitting, except
where noted.
•
Leave excess grease on fitting to keep
out dirt.
•
Replace any loose or broken fittings
immediately.
•
If fitting will not take grease, remove and
clean thoroughly. Also clean lubricant
passageway. Replace fitting if necessary.
Model
Applicable page numbers
Header drive
Hay conditioner
Carrier
APT
A30-D
36 - 37
38
39
40
Summary of Contents for A30-D
Page 49: ...NOTES 169001 Revision F 47...