MacDon A30-D, Unloading And Assembly Instructions

Page: 21 / 51

UNLOADING AND ASSEMBLY
169001 Revision F
19
g. Assemble PTO driveline male half (G) onto PTO
shaft (H) on APT. Push male half so that PTO
shaft is at its fully compressed length.
h. Locate PTO shaft in hook (J).
III. ATTACH MOWER CONDITIONER TO
TRACTOR
a. Start engine, and position tractor to align
drawbar extension (A) with arm (B) on mower
conditioner APT.
CAUTION
Stop engine, and remove key from ignition
before leaving operator’s seat for any
reason. A child or even a pet could engage
an idling machine.
b. Set park brake, stop engine, and remove key.
c. Remove pin (C).
d. Raise jack (D) to engage arm (B) on drawbar
extension (A).
e. Install hitch-pin (C), and secure with hairpin.
IMPORTANT
If tractor has a three-point hitch, lower the
lower links as low as possible to prevent
damage to APT.
f. Attach driveline (E) to tractor PTO shaft
as follows:
1. Position driveline onto tractor PTO shaft (F).
2. Pull back collar on driveline, and push until it
locks. Release collar.
g. Route safety chain from mower conditioner
through chain support (G) around drawbar
support, and lock the hook (H) on chain.
(continued next page)
H
G
J
A
B
C
B A
C
D
E
F
H
G