PRE-DELIVERY CHECKS
169001
Revision F
46
I. KNIFE
a. Check guards for signs of heating during run-up
due to insufficient clearance between guard
and knife.
b. If heating is evident, proceed as follows:
1. Check gap between knifehead and pitman
arm. A business card should slide easily
through the gap. If not, then adjust gap by
loosening bolt, and tapping knifehead with a
hammer. Retighten bolt.
2. Adjust guard alignment as follows: The
guard straightening tool (MD#140135) is
available from your MacDon Dealer:
i. Position tool as shown, and pull up.
ii. Position tool as shown, and push down.
J. MANUALS
a. The following manuals shipped with this product
should be placed and stored in the manual
storage case on the RH end of the carrier frame
for safe keeping and future reference.
•
A30-D Pull-Type Mower Conditioners
Unloading and Assembly Instructions,
MD #169001
•
A-Series Operators Manual,
MD #169000
•
A-Series Parts Catalog, MD #169002
b. The “Predelivery Checklist” (yellow sheet
attached to this manual) should be retained by
either the Dealer or the Operator.
Downward adjustment
Upward adjustment
Summary of Contents for A30-D
Page 49: ...NOTES 169001 Revision F 47...
