UNLOADING AND ASSEMBLY
169001
Revision F
28
STEP 16. INSTALL FORMING
SHIELD COVER
a. Loosen carriage bolt (A) securing forming shield
to frame at each side of shield.
b. Remove two 1/2 in. x 1.25 carriage bolts (B)
from each side of forming shield, and retain for
reinstallation.
c. Remove eight 3/8 in. x .75 bolts (C) along top of
shield, and two (D) bolts at center that will be
used to secure shield to frame once it is
in place.
d. Swing forming shield into position, and support it
so that the 1/2 in. x 1.25 carriage bolts (B) can
be reinstalled. Bolt heads to be facing inboard.
Leave bolts loose.
e. Install two 3/8 in. x .75 carriage bolts (D) at
center support.
f. Fasten forming shield to frame with 3/8 in. x .75
carriage bolts (C) and serrated nuts at
eight places.
g. Tighten all hardware.
STEP 17. INSTALL SIDE
DEFLECTORS
a. Remove bolt (E), washers, and nut that attaches
adjuster bar (F) to side deflector (G). Note
location of washers relative to adjuster bar.
Retain hardware.
b. Remove nuts (H) from support rod.
c. Install each side deflector support rod through
frame at (J), and secure with 3/4 in. hex
nuts (H). Hardware (H) must be tight enough to
hold deflectors in position, but still allow
positioning with adjuster bars.
NOTE
Swing deflector to inboard position to
assist installation.
d. If forming shield side deflectors are too loose, or
if they bind when moved with adjuster bars, back
off top nut at (H), and adjust lower nut at (H) as
required. Then, holding lower nut with a wrench,
tighten top nut securely against lower nut.
(continued next page)
RH SHOWN – LH
H
J
E
G
F
H
B
C
C
D
B
A
C
D
Summary of Contents for A30-D
Page 49: ...NOTES 169001 Revision F 47...
